In the IPv4 Address field enter the IPv4 address of the end point to be used. Note: If you chose LAN (Local Network) in Step 4, skip to Step 6. Other IP - Uses a LAN IPv4 address other than the local interface as the end point address.LAN (Local Network) - Uses the LAN interface (as long as the LAN is configured as an IPv4 network) as the local end point address. In the Local End Point Address field, click one of the radio buttons to choose the type of endpoint address to be used for the tunnel that starts with the router. Enter the name of the tunnel in the Tunnel Name fie The Add / Edit ISATAP Tunnel Configuration window appears: Use the Router Configuration Utility to choose Networking > IPv6 > Tunneling. The Intra-Site Automatic Tunnel Addressing Protocol (ISATAP) being an IPv6 transition protocol, provides for the automatic conversion of an IPv4 address to an IPv6 address, as well as a mechanism for setting up a virtual IPv6 network that transmits over an IPv4 network. The method to transmit IPv6 packets between dual-stack nodes over an IPv4 network is called ISATAP (Intra-Site Automatic Tunnel Addressing Protocol). This article explains how to configure ISATAP tunnels on the RV180 and RV180W routers. Intra-Site Automatic Tunnel Addressing Protocol (ISATAP) Tunnel Configuration on RV180 and RV180W Routers Objective
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |